Configuring Ip Profiles - AudioCodes Mediant 800B User Manual

User's Manual
Parameter
Index
allowed-video-coders <group index/coder index>
[AllowedVideoCoders_AllowedVideoCodersIndex]
User Define Coder
user-define-coder
[AllowedVideoCoders_UserDefineCoder]
19.4

Configuring IP Profiles

The IP Profiles table lets you configure up to 20 IP Profiles. An IP Profile is a set of
parameters with user-defined settings relating to signaling (e.g., SIP message terminations
such as REFER) and media (e.g., coder type). An IP Profile can later be assigned to
specific IP calls (inbound and/or outbound). Thus, IP Profiles provide high-level adaptation
when the device interworks between different IP entities, each of which may require
different handling by the device. This can include, for example, transcoding or even
transrating (of packetization time). For example, if a specific IP entity uses the G.711 coder
only, you can configure an IP Profile with G.711 for this IP entity.
To use your IP Profile for specific calls, you need to assign it to any of the following:

IP Groups - see 'Configuring IP Groups' on page 344

Gateway application: Tel-to-IP routing rules - see Configuring Tel-to-IP Routing Rules
on page 485

Gateway application: IP-to-Tel routing rules - see Configuring IP-to-Tel Routing Rules
on page 494
For the Gateway application: The device selects the IP Profile as follows:

If you assign different IP Profiles (not default) to the same specific calls in all of the
above-mentioned tables, the device uses the IP Profile that has the highest preference
level (as set in the 'Profile Preference' parameter). If these IP Profiles have the same
preference level, the device uses the IP Profile that you assigned in the IP Groups
table.

If you assign different IP Profiles to all of the above-mentioned tables and one table is
set to the default IP Profile, the device uses the IP Profile that is not the default.
Many of the parameters in the IP Profiles table have a corresponding "global" parameter.
For calls that are not associated with any IP Profile, the settings of the "global" parameters
are applied.
Note:
AlwaysUseRouteTable parameter is set to 1).
The following procedure describes how to configure IP Profiles through the Web interface.
You can also configure it through ini file (IPProfile) or CLI (configure voip > coders-and-
profiles ip-profile).
Version 7.2
IP Profiles can also be implemented when using a Proxy server (when the
Description
Defines an index number for the new table row.
Note: Each row must be configured with a unique
index.
Defines a user-defined coder.
The valid value is a string of up to 24 characters
(case-insensitive). For example, "HD.123"
(without quotes).
Note: Each coder can be configured only once
per Allowed Video Coders Group.
405 Mediant 800B Gateway & E-SBC
19. Coders and Profiles