AudioCodes Mediant 800B User Manual page 1254

1xx Response
404 Not Found
405 Method Not
Allowed
406 Not
Acceptable
407 Proxy
Authentication
Required
408 Request
Timeout
409 Conflict
410 Gone
411 Length
Required
413 Request Entity
Too Large
415 Unsupported
Media
420 Bad Extension
423 Interval Too
Brief
433 Anonymity
Disallowed
480 Temporarily
Unavailable
481 Call
Leg/Transacti
on Does Not
Exist
User's Manual
The device generates this response if it is unable to locate the callee. Upon
receiving this response, the device notifies the User with a Reorder Tone.
The device doesn't generate this response. Upon receipt of this message
and before a 200 OK has been received, the device responds with an ACK
and disconnects the call.
The device doesn't generate this response. Upon receipt of this message
and before a 200 OK has been received, the device responds with an ACK
and disconnects the call.
Authentication support for Basic and Digest. Upon receiving this message,
the device issues a new request according to the scheme received on this
response.
The device generates this response if the no-answer timer expires. Upon
receipt of this message and before a 200 OK has been received, the device
responds with an ACK and disconnects the call.
The device doesn't generate this response. Upon receipt of this message
and before a 200 OK has been received, the device responds with an ACK
and disconnects the call.
The device doesn't generate this response. Upon receipt of this message
and before a 200 OK has been received, the device responds with an ACK
and disconnects the call.
The device doesn't generate this response. Upon receipt of this message
and before a 200 OK has been received, the device responds with an ACK
and disconnects the call.
The device doesn't generate this response. Upon receipt of this message
and before a 200 OK has been received, the device responds with an ACK
and disconnects the call.
If the device receives a 415 Unsupported Media response, it notifies the
User with a Reorder Tone.
The device generates this response in case of SDP mismatch.
The device doesn't generate this response. Upon receipt of this message
and before a 200 OK has been received, the device responds with an ACK
and disconnects the call.
The device does not generate this response. On reception of this message
the device uses the value received in the Min-Expires header as the
registration time.
If the device receives a 433 Anonymity Disallowed, it sends a
DISCONNECT message to the PSTN with a cause value of 21 (Call
Rejected). In addition, the device can be configured, using the Release
Reason Mapping, to generate a 433 response when any cause is received
from the PSTN side.
If the device receives a 480 Temporarily Unavailable response, it notifies
the User with a Reorder Tone.
This response is issued if there is no response from remote.
The device doesn't generate this response. Upon receipt of this message
and before a 200 OK has been received, the device responds with an ACK
and disconnects the call.
1254
Mediant 800B Gateway & E-SBC
Comments
Document #: LTRT-10298