AudioCodes Mediant 800B User Manual page 497

User's Manual

Rule 3: If the incoming IP call has a From URI host prefix as abcd.com, the call is
routed to Trunk Group ID 4.
Table 23-4: IP-to-Tel Routing Table Parameter Description
Parameter
General
Index
[PstnPrefix_Index]
Name
route-name
[PstnPrefix_RouteName]
Match
Source IP Group
src-ip-group-id
[PstnPrefix_SrcIPGroupName]
Source SIP Interface
src-sip-interface-name
[PstnPrefix_SrcSIPInterfaceName]
Source IP Address
src-ip-address
[PstnPrefix_SourceAddress]
Version 7.2
Defines an index number for the new table row.
Note: Each row must be configured with a unique index.
Defines an arbitrary name to easily identify the row.
The valid value is a string of up to 20 characters. By default, no
value is defined.
Note: Each row must be configured with a unique name.
Assigns an IP Group from where the SIP message (INVITE) is
received.
By default, no value is defined.
To configure IP Groups, see 'Configuring IP Groups' on page
344.
The IP Group can be used as the 'Serving IP Group' in the
Accounts table for obtaining authentication username/password
for the call. To configure registration accounts, see 'Configuring
Registration Accounts' on page 371.
Defines the SIP Interface on which the incoming IP call is
received.
The default is Any (i.e., any SIP Interface).
To configure SIP Interfaces, see Configuring SIP Interfaces on
page 336.
Note: If the incoming INVITE is received on the specified SIP
Interface and the SIP Interface associated with the specified IP
Group in the 'Source IP Group' parameter (in this table) is
different, the incoming SIP call is rejected. If the 'Source IP
Group' parameter is not defined, the SIP Interface associated
with the default SRD (Index 0) is used. If there is no valid source
IP Group, the call is rejected.
Defines the source IP address of the incoming IP call.
The IP address can be configured in dotted-decimal notation
(e.g., 10.8.8.5) or as an FQDN. By default, no value is defined.
Note:

If the address is an FQDN, DNS resolution is done according
to the DNSQueryType parameter.

The source IP address is obtained from the Contact header in
the INVITE message.

You can configure from where the source IP address is
obtained, using the SourceIPAddressInput parameter.

The source IP address can include the following wildcards:

"x": denotes single digits. For example, 10.8.8.xx
represents all the addresses between 10.8.8.10 and
10.8.8.99.

"*": denotes any number between 0 and 255. For
497
Description
Mediant 800B Gateway & E-SBC
23. Routing