AudioCodes Mediant 800B User Manual page 1071

User's Manual
Parameter
configure voip > media voice codecs >
G726-voice-payload-format
[VoicePayloadFormat]
MF Transport Type
configure voip > media voice > MF-
transport-type
[MFTransportType]
Silence Suppression
configure voip > media voice > silence-
compression-mode
[EnableSilenceCompression]
Echo Canceler
configure voip > media voice > echo-
canceller-enable
[EnableEchoCanceller]
Network Echo Suppressor Enable
configure voip/media voice/acoustic-
echo-suppressor-enable
[AcousticEchoSuppressorSupport]
Version 7.2
67. Configuration Parameters Reference
settings of the global parameter is ignored for calls
associated with the profile.
Determines the bit ordering of the G.726 voice payload
format.

[0] = (Default) Little Endian

[1] = Big Endian
Note:

To ensure high voice quality when using G.726, both
communicating ends should use the same endianness
format. Therefore, when the device communicates with
a third-party entity that uses the G.726 voice coder and
voice quality is poor, change the settings of the
parameter (between Big Endian and Little Endian).
Currently, not supported.
Global parameter that enables the Silence Suppression
feature. You can also configure this functionality per
specific calls, using IP Profiles (IpProfile_SCE). For a
detailed description of the parameter and for configuring
this functionality in the IP Profiles table, see 'Configuring IP
Profiles' on page 405.
Note:

If this functionality is configured for a specific profile, the
settings of this global parameter is ignored for calls
associated with the profile.
Global parameter enabling echo cancellation (i.e., echo
from voice calls is removed).
You can also configure this functionality per specific calls,
using IP Profiles (IpProfile_EnableEchoCanceller) or Tel
Profiles (TelProfile_EnableEC). For a detailed description
of the parameter and for configuring the functionality, see
'Configuring IP Profiles' on page
Profiles on page 439.
Note:

If the functionality is configured for a specific profile, the
settings of this global parameter is ignored for calls
associated with the profile.
Enables the network Acoustic Echo Suppressor feature on
SBC calls. This feature removes echoes and sends only
the near-end's desired speech signal to the network (i.e., to
the far-end party).

[0] Disable (default)

[1] Enable
Note:

For the parameter to take effect, a device reset is
required.
1071
Description
405 or Configuring Tel
Mediant 800B Gateway & E-SBC