AudioCodes Mediant 800B User Manual page 1197

User's Manual
Parameter
Use EndPoint Number As
Calling Number Tel2IP
epn-as-cpn-tel2ip
[UseEPNumAsCallingNumTel2
IP]
Use EndPoint Number As
Calling Number IP2Tel
epn-as-cpn-ip2tel
[UseEPNumAsCallingNumIP2
Tel]
Tel2IP Default Redirect
Version 7.2

[1] Enable
During the blind transfer, the device initiates a new call to the PSTN
and the destination number of this call can be manipulated if the
parameter is enabled. When enabled, the manipulation is done as
follows:
If you configure a value for the xferPrefix parameter, the value
1
(string) is added as a prefix to the number in the Refer-To
header.
This called party number is then manipulated using the
2
Destination Phone Number Manipulation for IP-to-Tel Calls table.
The source number of the transferred call is taken from the
original call, according to its initial direction:

Source number of the original call if it is a Tel-to-IP call

Destination number of the original call if it is an IP-to-Tel call
This source number can also be used as the value for the
'Source Prefix' field in the Destination Phone Number
Manipulation for IP-to-Tel Calls table. The local IP address is
used as the value for the 'Source IP Address' field.
Note:

This manipulation does not affect IP-to-Trunk Group routing
rules.

The parameter is applicable only to digital interfaces.
Enables the use of the B-channel number as the calling number
(sent in the From field of the INVITE) instead of the number received
in the Q.931 Setup message, for Tel-to-IP calls.

[0] Disable (default)

[1] Enable
For example, if the incoming calling party number in the Q.931
Setup message is "12345" and the B-channel number is 17, then the
outgoing INVITE From header is set to "17" instead of "12345".
Note:

When enabled, this feature is applied before routing and
manipulation on the source number.

The parameter is applicable only to digital interfaces.
Enables the use of the B-channel number as the calling party
number (sent in the Q.931 Setup message) instead of the number
received in the From header of the INVITE, for IP-to-Tel calls.

[0] Disable (default)

[1] Enable
For example, if the incoming INVITE From header contains "12345"
and the destined B-channel number is 17, then the outgoing calling
party number in the Q.931 Setup message is set to "17" instead of
"12345".
Note:

When enabled, this feature is applied after routing and
manipulation on the source number (i.e., just before sending to
the Tel side).

The parameter is applicable only to digital interfaces.
Determines the default redirect reason for Tel-to-IP calls when no
1197
67. Configuration Parameters Reference
Description
Mediant 800B Gateway & E-SBC