Identifying Audiocodes Syslog Messages Using Facility Levels - AudioCodes Mediant 800B User Manual

Error Abbreviation
MR
OR
PH
PL
RB
RD
RO
RP
RS
UF
AA
AC
AL
AO
AP
AR

60.2.1.2 Identifying AudioCodes Syslog Messages using Facility Levels

The device's Syslog messages can easily be identified and distinguished from Syslog
messages from other equipment, by setting its Facility level. The Facility levels of the
device's Syslog messages are numerically coded with decimal values. Facility level may
use any of the "local use" facilities (0 through 7), according to RFC 3164. Implementing
Facility levels is useful, for example, if you collect the device's as well as other equipments'
Syslog messages on the same server. Therefore, in addition to filtering Syslog messages
by IP address, you can filter messages by Facility level.

To configure the Facility level:

Configure the SyslogFacility ini file parameter to one of the following options:
Numerical Value
16 (default)
17
18
19
20
21
22
User's Manual
Modem Relay Is Not Supported
DSP JB Overrun
Packet Header Error
RTP Packet Loss
Counts the number of BFI Frames Received From The Host
No Available Release Descriptor
RTP Reorder
Unknown RTP Payload Type
RTP SSRC Error
Unrecognized Fax Relay Command
Invalid Accumulated Packets Counter
Invalid Channel ID
Invalid Header Length
Invalid Codec Type
Unknown Aggregation Payload Type
Invalid Routing Flag Received
Table 60-5: Syslog Facility Levels
local use 0 (local0)
local use 1 (local1)
local use 2 (local2)
local use 3 (local3)
local use 4 (local4)
local use 5 (local5)
local use 6 (local6)
934
Mediant 800B Gateway & E-SBC
Error Name Description
Facility Level
Document #: LTRT-10298