Onu Interface Qos Configuration; Configuring The Trust Precedence - Zte ZXA10 C300 Configuration Manual

ZXA10 C300 Configuration Manual (CLI)
ZXAN(config-if)#show traffic-profile test
-----------------------------------------------------------------
profile name
profile detail
-----------------------------------------------------------------
basic traffic type
committed information rate : 10240 kbps
committed burst size
peak information rate
peak burst size
discard mode
color mode
-----------------------------------------------------------------
profile used by :
gpon-olt_1/5/1
– End of Steps –

7.3 ONU Interface QoS Configuration

7.3.1 Configuring the Trust Precedence

This section describes how to configure the ONU virtual port (vport) to trust CoS or DSCP
priority of packets.
Context
When the vport trusts
l When the vport trusts CoS priority, the CoS in packets is marked in the override >
cos-remark > trust order based on the ingress CoS.
l
When the vport trusts DSCP priority, the CoS is marked according to the configured
DSCP-to-CoS mapping relation.
Steps
1. In ONU interface configuration mode, configure the trust precedence of the vport.
ZXAN(config)#interface gpon-onu_1/5/1:1
ZXAN(config-if)#qos trust dscp vport 1
ZXAN(config-if)#qos trust cos vport 2
2. (Optional) Query the QoS configuration on the interface.
ZXAN(config-if)#show qos interface gpon-onu_1/5/1:1
qos trust dscp vport 1
SJ-20130520164529-007|2013-06-30 (R1.0)
: TEST
:
: ip
: 1000 kbytes
: 20480 kbps
: 1000 kbytes
: low priority first
: blind
CoS or DSCP priority, there are two cases:
7-8
ZTE Proprietary and Confidential