Zte ZXA10 C300 Configuration Manual page 214

ZXA10 C300 Configuration Manual (CLI)
4. Enable the MPLS on the VLAN interface.
ZXAN(config-if-vlan10)#mpls ip
ZXAN(config-if-vlan10)#exit
5. Configure the routing protocol.
ZXAN(config)#router ospf 1
ZXAN(config-router)#network 1.1.1.1 0.0.0.0 area 0.0.0.0
ZXAN(config-router)#network 10.1.1.0 0.0.0.255 area 0.0.0.0
ZXAN(config-router)#exit
6. Enable the global MPLS function.
ZXAN(config)#vlan-reserve 4090 vpn
ZXAN(config)#ip mpls-forwarding enable
ZXAN(config)#mpls ldp router-id loopback1
ZXAN(config)#mpls ip
7. Configure the LDP target session.
ZXAN(config)#mpls ldp target-session 3.3.3.3
8. Configure the VC.
ZXAN(config)#pw 3and1000pw
ZXAN(config-pw)#mode dynamic pwe3 fec128
ZXAN(config-pw)#pwtype ethernet
ZXAN(config-pw)#peer 3.3.3.3 router-id 3.3.3.3 vcid 1000
ZXAN(config-pw)#exit
9. Configure the VLL.
ZXAN(config)#vll pwe3-vll
ZXAN(config-vll)#service-type ethernet
ZXAN(config-vll)#mpls xconnect pw 3and1000pw
ZXAN(config-vll)#exit
10. Configure the class map.
ZXAN(config)#class-map classmap1000
ZXAN(config-cmap)#match svlan-id 1000
ZXAN(config-cmap)#exit
11. Configure the CIP.
ZXAN(config)#cip 1
ZXAN(config-cip1)#service-type ethernet class-map classmap1000
ZXAN(config-cip1)#xconnect pwe3-vll
ZXAN(config-cip1)#exit
12. Save the configuration data.
l Configuration on C300-2.
1. Configure the loopback interface.
ZXAN(config)#interface loopback1
ZXAN(config-loopback1)#ip address 2.2.2.2 255.255.255.255
SJ-20130520164529-007|2013-06-30 (R1.0)
16-58
ZTE Proprietary and Confidential