Zte ZXA10 C300 Configuration Manual page 222

ZXA10 C300 Configuration Manual (CLI)
ZXAN(config)#interface loopback1
ZXAN(config-loopback1)#ip address 2.2.2.2 255.255.255.255
ZXAN(config-loopback1)#exit
2. Configure the VLAN of the uplink interfaces.
ZXAN(config)#interface gei_1/21/1
ZXAN(config-if)#switchport vlan 11 tag
ZXAN(config-if)#exit
ZXAN(config)#interface gei_1/21/2
ZXAN(config-if)#switchport vlan 10 tag
ZXAN(config-if)#exit
3. Configure the IP address of the VLAN interface.
ZXAN(config)#interface vlan 10
ZXAN(config-if-vlan10)#ip address 10.1.1.2 255.255.255.0
ZXAN(config-if-vlan10)#exit
ZXAN(config)#interface vlan 11
ZXAN(config-if-vlan11)#ip address 11.1.1.1 255.255.255.0
ZXAN(config-if-vlan11)#exit
4. Enable the MPLS on the VLAN interfaces.
ZXAN(config)#interface vlan 10
ZXAN(config-if-vlan10)#mpls ip
ZXAN(config-if-vlan10)#exit
ZXAN(config)#interface vlan 11
ZXAN(config-if-vlan11)#mpls ip
ZXAN(config-if-vlan11)#exit
5. Configure the routing protocol.
ZXAN(config)#router ospf 1
ZXAN(config-router)#network 2.2.2.2 0.0.0.0 area 0.0.0.0
ZXAN(config-router)#network 10.1.1.0 0.0.0.255 area 0.0.0.0
ZXAN(config-router)#network 11.1.1.0 0.0.0.255 area 0.0.0.0
ZXAN(config-router)#exit
6. Enable the global MPLS function.
ZXAN(config)#vlan-reserve 4090 vpn
ZXAN(config)#ip mpls-forwarding enable
ZXAN(config)#mpls ldp router-id loopback1
ZXAN(config)#mpls ip
7. Configure the LDP target sessions.
ZXAN(config)#mpls ldp target-session 1.1.1.1
ZXAN(config)#mpls ldp target-session 3.3.3.3
8. Configure the VCs.
ZXAN(config)#pw 1and2000pw
ZXAN(config-pw)#mode static fec128
SJ-20130520164529-007|2013-06-30 (R1.0)
16-66
ZTE Proprietary and Confidential