Zte ZXA10 C300 Configuration Manual page 230

ZXA10 C300 Configuration Manual (CLI)
4. Enable the MPLS on the VLAN interface.
ZXAN(config-if)#mpls ip
ZXAN(config-if)#exit
5. Configure the routing protocol.
ZXAN(config)#router ospf 1
ZXAN(config-router)#network 1.1.1.1 0.0.0.0 area 0.0.0.0
ZXAN(config-router)#network 10.1.1.0 0.0.0.255 area 0.0.0.0
ZXAN(config-router)#exit
6. Enable the global MPLS function.
ZXAN(config)#vlan-reserve 4090 vpn
ZXAN(config)#ip mpls-forwarding enable
ZXAN(config)#mpls ldp router-id loopback1
ZXAN(config)#mpls ip
7. Configure the LDP target session.
ZXAN(config)#mpls ldp target-session 3.3.3.3
8. Configure the PW class.
ZXAN(config)#pw-class 3and1000pw
ZXAN(config-pw-class)#control-word preferred
ZXAN(config-pw-class)#exit
9. Configure the VC.
ZXAN(config)#pw 3and1000pw
ZXAN(config-pw)#mode dynamic pwe3 fec128
ZXAN(config-pw)#pwtype e1
ZXAN(config-pw)#apply pw-class 3and1000pw
ZXAN(config-pw)#peer 3.3.3.3 router-id 3.3.3.3 vcid 1000
ZXAN(config-pw)#exit
10. Configure the VLL.
ZXAN(config)#vll tdm-vll
ZXAN(config-vll)#service-type tdm
ZXAN(config-vll)#mpls xconnect pw 3and1000pw
ZXAN(config-vll)#exit
11. Configure the CIP.
ZXAN(config)#cip 1
ZXAN(config-cip1)#service-type tdm-relay mpls 1046016 6016 1046015 6015 0015.eb72.
0004 1000
ZXAN(config-cip1)#xconnect tdm-vll
ZXAN(config-cip1)#exit
12. Configure the MAC address.
ZXAN(config)#mac 0015.eb72.0002 15
13. Save the configuration data.
SJ-20130520164529-007|2013-06-30 (R1.0)
16-74
ZTE Proprietary and Confidential