Configuring The Bfd For Vccv - Zte ZXA10 C300 Configuration Manual

ZXAN(config-if)#exit
3. Configure the IP address of the VLAN interfaces.
ZXAN(config)#interface vlan 11
ZXAN(config-if-vlan11)#ip address 11.1.1.2 255.255.255.0
ZXAN(config-if-vlan11)#exit
ZXAN(config)#interface vlan 12
ZXAN(config-if-vlan12)#ip address 12.1.1.1 255.255.255.0
ZXAN(config-if-vlan12)#exit
l
Configuration on C300-4.
1. Configure the loopback interface.
ZXAN(config)#interface loopback1
ZXAN(config-if)#ip address 4.4.4.4 255.255.255.255
ZXAN(config-if)#exit
2. Configure the VLAN of the uplink interfaces.
ZXAN(config)#interface gei_1/21/1
ZXAN(config-if)#switchport vlan 13 tag
ZXAN(config-if)#exit
ZXAN(config)#interface gei_1/21/2
ZXAN(config-if)#switchport vlan 12 tag
ZXAN(config-if)#exit
3. Configure the IP address of the VLAN interfaces.
ZXAN(config)#interface vlan 12
ZXAN(config-if-vlan12)#ip address 12.1.1.2 255.255.255.0
ZXAN(config-if-vlan12)#exit
ZXAN(config)#interface vlan 13
ZXAN(config-if-vlan13)#ip address 13.1.1.1 255.255.255.0
ZXAN(config-if-vlan13)#exit

17.2.2 Configuring the BFD for VCCV

BFD can be used for Virtual Circuit Connectivity Verification (VCCV) in MPLS network
OAM.
Networking Diagram
Figure 17-3
SJ-20130520164529-007|2013-06-30 (R1.0)
shows the networking diagram of the BFD for VCCV.
17-11
ZTE Proprietary and Confidential
Chapter 17 OAM Configuration