Zte ZXA10 C300 Configuration Manual page 124

ZXA10 C300 Configuration Manual (CLI)
In LACP mode, multiple physical ports are dynamically aggregated into a trunk group
to form a logical port, thus to balance the load of the egress/ingress flow among
the member ports. Aggregation is automatically generated to obtain the maximum
bandwidth.
The ZXA10 C300 link aggregation function complies with the following rules:
l
The link aggregation function supports up to eight trunk groups, and each trunk group
contains up to eight member ports.
l
The inter-interface card aggregation is supported, and the member ports can be
located on any interface card.
l
Member ports must operate in full duplex mode, and the working rates and VLAN
attributes must be consistent.
The logical port formed by link aggregation on the ZXA10 C300 is called smartgroup.
Smartgroup has the same default VLAN attributes as a common Ethernet port.
Steps
1. In global configuration mode, create a smartgroup.
ZXAN(config)#interface smartgroup1
ZXAN(config-smartgroup1)#
2. Configure load balancing mode.
ZXAN(config-smartgroup1)#smartgroup load-balance src-dst-mac
The ZXA10 C300 supports six load balancing modes that are based on source
IP, destination IP, source/destination IPs,
and source/destination MACs respectively.
source/destination MACs.
3. Configure LACP mode.
ZXAN(config-smartgroup1)#smartgroup mode 802.3ad
The ZXA10 C300 supports two LACP modes:
l
On: LACP static aggregation mode.
l
802.3ad: LACP dynamic negotiation mode
4. Configure the VLAN for the smartgroup.
ZXAN(config-smartgroup1)#switchport vlan 100 tag
SJ-20130520164529-007|2013-06-30 (R1.0)
Note:
Note:
source MAC, destination MAC,
The default mode is based on
12-2
ZTE Proprietary and Confidential