Zte ZXA10 C300 Configuration Manual page 126

ZXA10 C300 Configuration Manual (CLI)
ZXAN(config)#interface gei_1/21/1
ZXAN(config-if)#smartgroup 1 mode active
The ZXA10 C300 supports the following three port aggregation modes:
l
On: Static aggregation trunk. The two ends of the aggregation need to be set to
the on mode.
l Active: LACP active negotiation mode
l Passive: LACP passive negotiation mode
It is recommended to set the port at one end to the active aggregation mode, and set
the port at the other end to the passive aggregation mode, or set ports at both ends to
the active aggregation mode.
8. Configure the timeout mode of the port.
ZXAN(config-if)#lacp timeout long
The ZXA10 C300 supports the following two LACP timeout modes:
l Long (default): The adjacent port sends a LACPDU packet every 30s.
l
Short: The adjacent port sends a LACPDU packet every second.
The LACP timeout mode is valid only when the port is in active or passive aggregation
mode.
9. Configure other port in the aggregation group.
ZXAN(config)#interface gei_1/21/2
ZXAN(config-if)#smartgroup 1 mode active
ZXAN(config-if)#lacp timeout long
10. (Optional) Query the smartgroup status.
ZXAN(config-if)#show lacp internal
Smartgroup:1
Flag *--Loop is TRUE
Actor
Port
-----------------------------------------------------------------------------
gei_1/21/1
SJ-20130520164529-007|2013-06-30 (R1.0)
Note:
Note:
Switch attribute:TRUE
Agg LACPDUs
State Interval Priority Key
inactive 30
Mode:802.3ad
Port Oper Port
State Machine
32768 0x100 0x45
12-4
ZTE Proprietary and Confidential
RX Mux
Machine
port-disabled defaulted