Configuring Arp Proxy - Zte ZXA10 C300 Configuration Manual

ZXA10 C300 Configuration Manual (CLI)
2. Configure the gateway IP address of the MFF VLAN.
ZXAN(config)#ip-service mac-forced-forwarding vlan 100 gateway 10.1.1.1
3. (Optional) Query the global MFF configuration.
ZXAN(config)#show ip-service mac-forced-forwarding
Mac-Forced Forwarding status:Enabled.
4. (Optional) Query the gateway information of the MFF VLAN.
ZXAN(config)#show ip-service gateway
Vlan
--------------------------------------------------------
100
– End of Steps –

14.7 Configuring ARP Proxy

This section describes how to configure ARP proxy to implement interworking between
subscribers under the same PON port.
Context
By default, the ZXA10 C300 services on different ONUs under the same PON port are
isolated. When a service, such as VoIP, requires interworking between the subscribers
under the same PON port, the ZXA10 C300 uses the ARP proxy function to achieve
interworking between the subscribers in the same VLAN and same network segment under
the same PON port.
Steps
1. In layer-3 VLAN interface mode, configure the layer-3 interface IP address.
ZXAN(config)#interface vlan 100
ZXAN(config-if-vlan100))#ip address 10.1.1.1 255.255.255.0
The VLAN is the user VLAN. The IP address should be in the same network segment
as that of the interworking device.
2. Enable ARP proxy on the layer-3 interface.
ZXAN(config-if-vlan100))#ip proxy-arp
– End of Steps –
SJ-20130520164529-007|2013-06-30 (R1.0)
Gateway IP Gateway MAC
10.1.1.1 00d0.d0c7.0561
Note:
Type
dynamic-600s
14-14
ZTE Proprietary and Confidential