Chapter 18 Route Protocol Configuration; Configuring The Static Route; Configuring The Ospf Protocol - Zte ZXA10 C300 Configuration Manual

Chapter 18
Route Protocol Configuration
Besides static route, the ZXA10 C300 supports the following routing protocols:
l
OSPF
l
BGP
Table of Contents

Configuring the Static Route.....................................................................................18-1

Configuring the OSPF Protocol ................................................................................18-1

Configuring the BGP ................................................................................................18-2
18.1 Configuring the Static Route
This section describes how to implement the static route of the ZXA10 C300 by configuring
the next hop address to the destination network segment.
Context
Static route is the route info added into the routing table by the network administrator via
the configuration command. You can using static route with a few configurations to avoid
using dynamic routing. In the case that multiple routers and multiple paths exist, however,
dynamic routing is recommended.
Steps
1. In global configuration mode, configure the static route.
ZXAN(config)#ip route 10.1.1.0 255.255.255.0 1.1.1.2
– End of Steps –
18.2 Configuring the OSPF Protocol
This section describes how to implement the ZXA10 C300's access to the adjacent router
by configuring the OSPF protocol.
Context
OSPF is an Interior Gateway Protocol (IGP), used to determine the route in a single
Autonomous System (AS). OSPF is a link-state routing protocol.
weaknesses of RIP and other distance vector protocol.
OSPF version 1 is defined in RFC1131. OSPF version 2 is defined in RFC2328. The
ZXA10 C300 supports OSPF version 2.
SJ-20130520164529-007|2013-06-30 (R1.0)
18-1
ZTE Proprietary and Confidential
It overcomes the