Zte ZXA10 C300 Configuration Manual page 192

ZXA10 C300 Configuration Manual (CLI)
ZXAN(config)#class-map classmap1000
ZXAN(config-cmap)#match svlan-id 1000
ZXAN(config-cmap)#exit
11. Configure the CIP.
ZXAN(config)#cip 1
ZXAN(config-cip1)#service-type ethernet class-map classmap1000
ZXAN(config-cip1)#xconnect fullmesh-vfi
ZXAN(config-cip1)#exit
12. Save the configuration data.
l
Configuration on C300-2.
1. Configure the loopback interface.
ZXAN(config)#interface loopback1
ZXAN(config-loopback1)#ip address 2.2.2.2 255.255.255.255
ZXAN(config-loopback1)#exit
2. Configure the VLAN of the uplink interface.
ZXAN(config)#interface gei_1/21/1
ZXAN(config-if)#switchport vlan 11 tag
ZXAN(config-if)#exit
ZXAN(config)#interface gei_1/21/2
ZXAN(config-if)#switchport vlan 12 tag
ZXAN(config-if)#exit
3. Configure the IP address of the VLAN interfaces.
ZXAN(config)#interface vlan 11
ZXAN(config-if-vlan11)#ip address 10.1.1.1 255.255.255.0
ZXAN(config-if-vlan11)#exit
ZXAN(config)#interface vlan 12
ZXAN(config-if-vlan12)#ip address 20.1.1.2
ZXAN(config-if-vlan12)#exit
4. Enable the MPLS on the VLAN interfaces.
ZXAN(config)#interface vlan 11
ZXAN(config-if-vlan11)#mpls ip
ZXAN(config-if-vlan11)#exit
ZXAN(config)#interface vlan 12
ZXAN(config-if-vlan12)#mpls ip
ZXAN(config-if-vlan12)##exit
5. Configure the routing protocol.
ZXAN(config)#router ospf 1
ZXAN(config-router)#network 2.2.2.2 0.0.0.0 area 0.0.0.0
ZXAN(config-router)#network 10.1.1.0 0.0.0.255 area 0.0.0.0
ZXAN(config-router)#network 20.1.1.0 0.0.0.255 area 0.0.0.0
ZXAN(config-router)#exit
SJ-20130520164529-007|2013-06-30 (R1.0)
255.255.255.0
16-36
ZTE Proprietary and Confidential