Zte ZXA10 C300 Configuration Manual page 223

ZXAN(config-pw)#pwtype ethernet
ZXAN(config-pw)#peer 1.1.1.1 router-id 1.1.1.1 vcid 2000 local-label 1042432
remote-label 1042431
ZXAN(config-pw)#exit
ZXAN(config)#pw 3and2001pw
ZXAN(config-pw)#mode dynamic pwe3 fec128
ZXAN(config-pw)#pwtype ethernet
ZXAN(config-pw)#peer 3.3.3.3 router-id 3.3.3.3 vcid 2001
ZXAN(config-pw)#exit
9. Configure the multi-segment PW.
ZXAN(config)#mspw zte-mspw
ZXAN(config-mspw)#mpls xconnect pw 1and2000pw
ZXAN(config-mspw)#mpls xconnect pw 3and2001pw
ZXAN(config-mspw)#exit
10. Save the configuration data.
ZXAN(config)#exit
ZXAN#write
Building configuration...
.........................[OK]
l Configuration on C300-3.
1. Configure the loopback interface.
ZXAN(config)#interface loopback1
ZXAN(config-loopback1)#ip address 3.3.3.3 255.255.255.255
ZXAN(config-loopback1)#exit
2. Configure the VLAN of the uplink interfaces.
XAN(config)#interface gei_1/21/2
ZXAN(config-if)#switchport vlan 11 tag
ZXAN(config-if)#exit
3. Configure the IP address of the VLAN interface.
ZXAN(config)#interface vlan 11
ZXAN(config-if-vlan11)#ip address 11.1.1.2 255.255.255.0
4. Enable the MPLS on the VLAN interface.
ZXAN(config-if-vlan11)#mpls ip
ZXAN(config-if-vlan11)#exit
5. Configure the routing protocol.
ZXAN(config)#router ospf 1
ZXAN(config-router)#network 3.3.3.3 0.0.0.0 area 0.0.0.0
ZXAN(config-router)#network 11.1.1.0 0.0.0.255 area 0.0.0.0
ZXAN(config-router)#exit
6. Enable the global MPLS function.
ZXAN(config)#vlan-reserve 4090 vpn
SJ-20130520164529-007|2013-06-30 (R1.0)
Chapter 16 MPLS Service Configuration
16-67
ZTE Proprietary and Confidential