Zte ZXA10 C300 Configuration Manual page 250

ZXA10 C300 Configuration Manual (CLI)
10. Configure the VLL.
ZXAN(config)#vll redundancy-vll
ZXAN(config-vll)#mpls xconnect pw 1and1000pw
ZXAN(config-vll)#exit
11. Configure the class map.
ZXAN(config)#class-map classmap1000
ZXAN(config-cmap)#match svlan-id 1000
ZXAN(config-cmap)#exit
12. Configure the CIP.
ZXAN(config)#cip 1
ZXAN(config-cip1)#service-type ethernet class-map classmap1000
ZXAN(config-cip1)#xconnect redundancy-vll
ZXAN(config-cip1)#oam-mapping enable ldp
ZXAN(config-cip1)#exit
13. Save the configuration data.
l Configuration on C300-3.
1. Configure the loopback interface.
ZXAN(config)#interface loopback1
ZXAN(config-loopback1)#ip address 3.3.3.3 255.255.255.255
ZXAN(config-loopback1)#exit
2. Configure the VLAN of the uplink interface.
ZXAN(config)#interface gei_1/21/2
ZXAN(config-if)#switchport vlan 10 tag
ZXAN(config-if)#exit
3. Configure the IP address of the VLAN interface.
ZXAN(config)#interface vlan 10
ZXAN(config-if-vlan10)#ip address 30.1.1.2 255.255.255.0
4. Enable the MPLS on the VLAN interfaces.
ZXAN(config-if-vlan10)#mpls ip
ZXAN(config-if-vlan10)#exit
5. Configure the routing protocol.
ZXAN(config)#router ospf 1
ZXAN(config-router)#network 3.3.3.3 0.0.0.0 area 0.0.0.0
ZXAN(config-router)#network 30.1.1.0 0.0.0.255 area 0.0.0.0
ZXAN(config-router)#exit
6. Enable the global MPLS function.
ZXAN(config)#vlan-reserve 4090 vpn
ZXAN(config)#ip mpls-forwarding enable
ZXAN(config)#mpls ldp router-id loopback1
SJ-20130520164529-007|2013-06-30 (R1.0)
ZXAN(config-pw-group)#exit
16-94
ZTE Proprietary and Confidential