Zte ZXA10 C300 Configuration Manual page 71

7. Configure MVLAN multicast groups.
ZXAN(config)#igmp mvlan 201 group 224.1.1.1 to 224.1.1.3
8. Configure MVLAN source port.
ZXAN(config)#igmp mvlan 201 source-port gei_1/15/1
9. Configure MVLAN receiving port.
ZXAN(config)#igmp mvlan 201 receive-port gei_1/5/1
10. Save configuration data.
– End of Steps –
Follow-Up Action
The P2P interfaces supports the following configuration:
l QoS (refer to
l
DHCP
l
Port identification (refer to
l
Link aggregation (refer to
The DHCP configuration and port location configuration on the P2P interfaces are similar
to the configuration on the PON ONU interfaces.
The QoS configuration and link aggregation configuration on the P2P interfaces are similar
to the configuration on the Ethernet interfaces.
Note:
Usually, in the P2P service, the uplink card is the 9U-height Ethernet interface card GDFO.
In DHCP snooping configuration, only the 4.5U-height uplink cards can be used for uplink.
SJ-20130520164529-007|2013-06-30 (R1.0)
Chapter 7 QoS
(refer to Chapter 11 DHCP
14.1 Port Identification
12.1 Configuring Link
Chapter 4 P2P Service Configuration
Configuration)
Configuration)
Configuration)
Aggregation)
4-3
ZTE Proprietary and Confidential