Zte ZXA10 C300 Configuration Manual page 259

ZXAN(config-if)#exit
3. Configure the IP address of the VLAN interface.
ZXAN(config)#interface vlan 11
ZXAN(config-if-vlan11)#ip address 10.1.1.1 255.255.255.0
4. Enable the MPLS on the VLAN interface.
ZXAN(config-if-vlan11)#mpls ip
ZXAN(config-if-vlan11)#exit
5. Configure the routing protocol.
ZXAN(config)#router ospf 1
ZXAN(config-router)#network 2.2.2.2 0.0.0.0 area 0.0.0.0
ZXAN(config-router)#network 10.1.1.0 0.0.0.255 area 0.0.0.0
ZXAN(config-router)#exit
6. Enable the global MPLS function.
ZXAN(config)#vlan-reserve 4090 vpn
ZXAN(config)#ip mpls-forwarding enable
ZXAN(config)#mpls ldp router-id loopback1
ZXAN(config)#mpls ip
7. Configure the LDP target session.
ZXAN(config)#mpls ldp target-session 1.1.1.1
8. Configure the PW class.
ZXAN(config)#pw-class pw1
ZXAN(config-pw-class)#control-word not-preferred
ZXAN(config-pw-class)#cctype type2
ZXAN(config-pw-class)#cvtype lsp-ping bfd-ipudp-fo
ZXAN(config-pw-class)#exit
9. Configure the PW.
ZXAN(config)#pw 1and1000pw
ZXAN(config-pw)#mode dynamic pwe3 fec128
ZXAN(config-pw)#pwtype ethernet
ZXAN(config-pw)#apply pw-class pw1
ZXAN(config-pw)#peer 1.1.1.1 router-id 1.1.1.1 vcid 1000
ZXAN(config-pw)#exit
10. Configure the BFD session.
ZXAN(config)#mpls pw bfd 1and1000pw interval 10 min-rx 10 multiplier 3
11. Configure the VLL.
ZXAN(config)#vll redundancy-vll
ZXAN(config-vll)#mpls xconnect pw 1and1000pw
ZXAN(config-vll)#exit
12. Configure the class map.
SJ-20130520164529-007|2013-06-30 (R1.0)
Chapter 16 MPLS Service Configuration
16-103
ZTE Proprietary and Confidential