Rep 4.1.6 Edge Present Sensor - Xerox 8830 Service Manual

...REP 4.1.6 Edge Present Sensor

Parts List on PL 5.1
Removal
WARNING
Switch off the Scanner and disconnect the Power
Cord.
1. Remove the Right Side Panel (REP 4.1.1).
2. Remove the Rear Panel (REP 4.1.2).
3. (Figure 1): Prepare to remove the Edge Present Sensor.
NOTE: The string attached in step 3b is used later to pull the cable
back through the channel when the sensor is reinstalled.
String
Figure 1. Disconnecting Connector P1
7356 SCANNER
Channel
Attach a string at
least 30 in (76
cm) long to the
connector and
cable
A
Disconnect
Connector Pl
from the Control
PWB
01030A-COB
4. (Figure 2): Detach the Retaining Plate.
Figure 2. Removing the Edge Present Sensor
4/97
4-9
A
Remove the 2
screws, and
lower the
Retaining Plate
01028A-COB
REP 4.1.6