Xerox 8830 Service Manual page 183

Hide thumbs Also See for 8830:

Table of Contents

NOTE: The position of the Lower Turnaround

Baffle determines the position of the Upper

Turnaround Baffle, When the position of the

Lower Turnaround Baffle is correctly set, the

Upper Turnaround Baffle is correctly positioned,

Cut two strips of 0.030 inch (coral) shimstock

0.75 inches (20 mm) wide.

7. (Figure 3): Adjust the Media Transport to

Drum spacing to 0.030 ± 0.005 inch (0.76 ±

8. Reinstall the Transfer / Detack Corotron. Push

the corotron down and in the direction of the

Developer Module before tightening the

securing screw.

Place the shims into the

notches of the Turnaround

Baffle, one on each side

Figure 3. Adjusting the Media Transport to Drum Spacing

Ensure that the shims are

positioned between the Lower

Baffle and the Drum

Use a screwdriver to push the

Turnaround Baffle fully against the

shims and tighten the retaining

screws (front and rear)

The view is of the Media

Transport as seen at the

rear of the printer.

Show Quick Links

Chapters

Table of Contents