Xerox 8830 Service Manual page 448

c (Figure 5): Install the 8830 DDS Control Panel on the 7356 scanner.
A
Align holes in bracket
with holes in scanner
cover
While holding center screw
Install center screw com-
and Control Panel in place,
pletely, prior to mounting
raise the scanner cover
other screws.
slightly
Figure 5 Rear view of 8830 DDS Control Panel showing fastener alignment
Adhesive Backing
Figure 6 7356 Scanner Cable Guide
General Procedures
8830 DDS installation
E
install the two remaining nuts
and screws and fully tighten
Install nut on center
screw and hand tighten
Guide Opening
a/98
6-22
NOTE: In the following step, ensure that the location of the Cable Guides is mea-
sured and lightly indicated in pencil on the rear of the scanner prior to installation of
the Cable Guides. Due to the strength of the adhesive used to hold the guides in
place, they must be positioned correctly the first time.
NOTE: When Installing the Cable Guides, make sura that the Quids Openings are
directed towards the center of the scanner. This gives the Cable guides a seamless
appearance and loosens the possibility of them catching on clothing.
d. (Figure 7): Install the Cable Guides and route the Control Panel Cable.
Route the Control Panel Cable through the
Cable guides
Door Seam
.25 inches
(6.36mm)
Install Cable Guide a quarter inch
(6.35mm) to the right of the door
Figure 7 Rear of Scanner showing positioning of Cable Guides
Align the edge of the Cable Guide
with the edge of the Control Panel.
Center and mount the Cable Guide
to the rear side of the Top Cover
8830 DDS