Xerox 8830 Service Manual page 149

5. (Figure 2): Remove the Grid Channel.
2
Remove the Grid
Channel
Figure 2. Removing the Grid Channel
WARNING
Disposal of the Pin Array is carefully controlled
because it is made of a Beryllium Copper alloy.
Package the old Pin Array as a returned part
Also, be especially careful of the very sharp tips
on the Pin Array.
6. (Figure 3): Remove the Charge Scorotron Pin
Array.
7. Remove the Torsion Springs from the End
Blocks.
8830
Replacement
1. Install the Torsion Springs from the repair kit.
CAUTION
Be careful not to damage the tips of the new Pin
Array. Bent tips can cause Print Quality problems.
2. Install the Pin Array from the repair kit into the
End Blocks.
R3022K
Scorotron
Extrusion
Torsion Spring
2
Pull the Pin Array
and lift it off the
stud
Figure 3. Removing the Charge Scorotron Pin Array
1/98
4-65
3. Reinstall the End B locks into the Scorotron
Extrusion. Ensure that the Pin Array is positioned
in the Center Support (not shown) of the
Scorotron Extrusion.
4. After completing the reassembly, package the Pin
Array for return.
1
Spread open the
plastic extrusion and
lift out the End Block
Repeat Steps 1 - 3 at the
opposite end and remove the
Remove the Pin
Pin Array
Array from the tangs
of the torsion spring
End Block
REP 9.8