Xerox 8830 Service Manual page 132

Hide thumbs Also See for 8830:

Table of Contents

NOTE: In the following steps, "Left" and "Right"

describe machine locations as observed when you

are facing the Xerographic Module at the left side of

the Printer.

7. (Figure 3): Move the bearing out of the

Xerographic Module Frame (Left Side).

Lift the Drum Assembly

and move the bearing to

Carefully lower the

Drum Assembly

Disconnect the retaining

clip that holds the bearing

and rotate the clip out of

Figure 3. Moving the Bearing (Left Side)

8. (Figure 4); Move the bearing out of the

Xerographic Module Frame (Right Side).

Holding the gearbox out of the grommet, move the

Drum Assembly to the right while moving the

bearing out of the frame (Without Tag 8)

Loosen the wingnut and rotate

the gearbox to disengage the

bracket from the grommet

Figure 4. Moving the Bearing (Right Side)

9. (Figure 5): Carefully remove the Drum

Disconnect P/J

Assembly from the Printer and place it, Gear Box

down, in a safe place on the floor.

Figure 5. Removing the Drum Assembly

Show Quick Links

Chapters

Table of Contents