4. (Figure 4):
Reform the Terminal Locking
Tab.
2
Rotate the
terminal until it is
parallel with the
line on the tool
1
insert the locking tab on the
terminal over the hook on the
Extractor Tool
Figure 4. Reforming the Locking Tab
5. Reinstall the terminal to the pin position
from which it was removed.
6. Reinstall the individual module connectors
to the correct locations noted at the
beginning of this procedure. Refer to
Section
7
for
detail
of
configuration.
Molex Connector Repair Procedure
connector
1/98
6-36
8830