Xerox 8830 Service Manual page 460

28. (Figure 13): Route the new Scanner Harness, and Ul Power Harness.
General Procedures
Installation of Tags 7 and 6
A
Connect (he center connector of the Ul Power Harness
to J3 on the MCB.
Attach the middle connector
of the Scanner Harness to J5
on the MCB.
Figure 13 Overhead view of 8830 Controller showing routing of new Scanner and Ul Power Harnesses
Route the Ul Power Harness underneath the MCB (area
indicated by dotted lines). Then mount the other end of the
Ul Power Harness (J15) to the Connector Panel.
3/98
6-34
B
Attach the end of the UI
Power Harness (P1) to
the Hard Drive.
8830 DDS