Rep 9.2 Drum Assembly - Xerox 8830 Service Manual

REP 9.2 Drum Assembly

Parts List on PL 9.2
WARNING
Switch off the Main Power Switch. Disconnect the
Power Cord.
Removal
1. Loosen the screws and open the Rear Door.
2. Raise and latch the Top Cover.
3. Lift and rotate the Image Module to the Service
Position.
4. Lower the Media Transport Cover.
NOTE: Figure 1 shows only the Front Support
Bracket.
5. (Figure 1): Prepare the Front and Rear Support
Brackets for raising the Xerographic Module to
the Service Position.
REP 9.2
1
Lift the bracket at the tab in
order to disconnect the spring
5
Using the handles on the Web Oiler Assembly, pull back
the Xerographic Module so that the grove on the shaft
is captured by the Support Bracket (Front and Rear)
Figure 1. Preparing the Support Bracket
1/98
4-46
2
3
Pull the spring away from the
Push the bracket down to the
shaft
horizontal position
Perform Steps 1 thru 3 for
the Rear Support Bracket
8830