Xerox 8830 Service Manual page 456

11. (Figure 6): Remove the MCB / Connector Panel Plate from the 8830 Controller Chassis.
Connector Panel Plate
A
Remove 6 screws indi-
cated from the front of
the 8830 Controller
Chassis
General Procedures
Installation of Tags 7 and 8
Figure 6 Removing the MCB and the Connector panel Plate from the 8830 Controller Chassis
3/98
6-30
B
Slide the MCB / Connector
panel Plate Back slightly in
the Chassis. Then lift it out
of the Chassis, Connector
Panel side first.
Place the MCB / Connector Panel
Plate on the ESD mat.
8830 DDS