Xerox 8830 Service Manual page 463

Change Tag / Mod Index
Introduction
All Important modifications are Identified by a Tab / MOD number on a matrix label attached to
each scanner Inside the Top Cover.
This section describes all the lags as well as multinational applicability, classification codes,
and permanent or temporary modification Information.
Classification Codas
A Tag/ MOD number may be required to Identify differences between parts that cannot be
Interchanged, or differences In Diagnostic, Repair, Installation, or Adjustment procedures. A
Tag/ MOD number may also be required to identify the presence of optional hardware, firm-
ware, or whether mandatory modifications have been Installed. Each Tag/ MOD number is
given a classification code to Identify the particular type of change that's been made. The fol-
lowing is a listing of these codes:
• M - Mandatory
• N- Not Installed in the field
• O • Optional
• R - Repair
• S - Situation
8830 DDS
Table 1 Document Loading Bins and Document Catch Tray
TAG/MOD
Class:
Use:
Mfg. Serial No.:
Name: Document Loading Bins and Document Catch
Tray
Purpose: Platform to hold documents to be printed and doc-
uments that have been printed.
Kit Number: 98S4022
Reference:
Table 2 8830 DDS Control Panel Kit
TAG/MOD
Class:
Use:
Mfg. Serial No.:
Name: 8830 DDS Control Panel Kit
Purpose:
Kit Number: 98K2044
Reference:
NOTE: The Change Tag /Mod Index entries for Tags 7 and 8 are listed in Section 6 of the
8830 Controller Manual.
3/98
6-37
General Procedures
Change Tag / Mod Index