Rep 8.3 Buckle Switch - Xerox 8830 Service Manual

REP 8.3 Buckle Switch

Parts List on PL 8.4
WARNING
Switch off the Main Power Switch. Disconnect the
Power Cord.
Removal
1. Latch the Xerographic Module at the Service
Position (REP 9.2).
2. Remove the Media Transport Assembly (REP
8.1).
3. Remove the Fabric Guide (REP 8.9).
4. Remove the Pressure Plates (REP 8.5).
5. (Figure 1): Remove the Buckle Switch.
a. Remove the screw.
b. Carefully pull the Buckle Switch Assembly
until the connector can be disconnected.
c. Disconnect the connector.
. d. Remove the Buckle Switch from the bracket.
8830
Screw
Figure 1. Removing the Buckle Switch
1/98
4-21
Buckle Switch
R3026K
REP 8.3