14. (Figure 8): Remove the Developer Module.
Ensure that the Gear
Lock is pulled back
Slide gear to left and
lock into position with
Gear Lock
Press in and rotate
Retaining Clip to DOWN
Remove the
position
Developer Module and
place it on a flat
surface
Figure 8. Removing the Developer Module
Installation
15. (Figure 9): Remove the Sump Shield.
Remove front
screws
R3021K
Rotate and remove the Sump
Shield
Use a straightedge to
remove the Sump
Shield from the Rear
Edge
1/98
6-18
Remove the Top
Shield
Remove full length of Sump
Shield lip from under the Front
Edge
Figure 9. Removing the Sump Shield
Loosen rear screws
Sump Shield
8830