Xerox 8830 Service Manual page 21

Status Code Entry Chart (cont.)
Status
Code
J1-01 Toner sensor error
Out of toner.
Cartridge home sensor error
J2-02
Toner cartridge could not find the home
position.
LL-00 Communication error
Applies only to printers with a bit mapped
user interface (FX).
LL-02 Check sum test error
Both message ROMs have failed the
checksum test immediately after power up.
LL-05 Fuser oil web error
NVM count of web encoder pulses indicates
the fuser oil web has reached end of life.
LL-06 Fuser oil web error
No encoder pulses are being received from
the fuser oil web.
LL-07 Fuser oil web error
Web Oiler Assembly
connected.
LL-10 Module wrap-around error
The paper transport assembly or the
Xerographic module is disconnected.
Description
Toner sensor (A22Q1).
Main PWB(A3)
Cartridge Home Sensor (A22Q2)
Main PWB (A3)
Cartridge Drive Motor
Cartridge Drive Gear
Web oiler motor (A23MOT1)
Driver PWB (A2)
CONTROL EPROMS
Web oiler optical switch (A23S2)
Web oiler motor (A23MOT1)
Driver PWB (A2)
P/J 4, wiring harness, pins
connector not Driver PWB (A2)
NOTE: Tag 3 must be installed for
this code. If not, disable the fault
detection using [10-35]
Xerographic module (A23)
Paper transport assembly (A21)
Driver PWB (A2)
Components
RAP
NO
NO
NO
NO
NO
NO
1/98
1-13
Comp BSD Ref PL
Code Ref
[0921-6] 9.7 PL 9.9
PL 1.3
[901]
9.7 PL 9.9
PL 1.3
[1034]
10.2 PL 10.4
[1033]
10.2 PL 10.4
[1033]
10.2 PL 10.4
[0701]
7.5 PL 1.1
Status Code Entry Chart