Xerox 8830 Service Manual page 458

18. Remove the 8 mounting screws that secure the M C B to the old Connector Panel Plate.
(See Figura 9 for location of screws.)
19. Remove the MCB from the old Connector Panel Plata and placa it on the ESD mat. (Dis-
card the old Connector Panel Plate.)
NOTE In the following reassembly steps, tighten the eight (8) mounting screws finger-
tight only. When all the hardware la correctly positioned, fully tighten the mounting
screws.
20. (Figura 9): Placa the MCB on the new Connector Panel Plata, and secure It with the
hardware previously removed.
Install and lightly tighten
the 8 screws Indicated
New Connector
Panel Plate
Figure 9 Installation of MCB onto new Connector Panel Plate
General Procedures
Installation of Tags 7 and 8
21. (Figure 10): Transfer ell hardware removed from the old Connector Panel Plato to the
now Connector Panel Plate.
A
Install 2 screws and 2 Cover Plates. (If Network Interface
card has been Installed, disregard replacement of plate on
left.).
Reinstall and tighten all
hardware indicated
Figure 10 Installing hardware on new Connector Panel
22. Tighten the eight mounting screws set into position in step 17.
3/98
6-32
8830 DDS