Installation - Other Systems - Xerox 8830 Service Manual

Installation - Other Systems

Do the following steps to install the scanner on a third party system:
1. Prepare the Scanner for installation. Refer to Scanner Preparation
in this section.
2. Switch off the host computer in the system in which the Scanner is
to be installed.
3. If required, install the SCSI Adapter PWB in the customer's control
computer. Refer to the documentation included with the SCSI
Adapter PWB.
4. Determine the SCSI addresses of the other equipment in the
system.
5. (Figure 6-28): If SCSI address 0 (zero) Is used by an existing device
in the system, switch the SCSI Address Selector on the Scanner to
an unused address.
Note: The Scanner is an internally terminated device, and should be
the last device on the SCSI chain.
computer and the Scanner should not be terminated.
6. Using a SCSI cable with the correct connectors, connect the SCSI
Port on the Scanner to the SCSI port on the last device in the
existing system.
7. Remove any SCSI Terminator from the device to which the Scanner
was connected in the previous step.
8. Switch on the Scanner.
9. Switch on the other devices in the system.
10. Switch on the host computer and allow it to complete the boot
process.
Scanner Installation
Devices between the Control
COB034A
Figure 6-28. Setting the SCSI Address of the Scanner
12/97
6-28
Rotate the SCSI Address
Selector until the arrow points
to the address desired.
7356 Scanner