Operation for the creation of 8.3 filename is disabled
Operating procedure
1.
Enable the creation of 8.3 filename.
2.
Insert the CD-ROM in the CD-ROM drive.
3.
Display the "Run" screen from the Start Menu or Quick Access Menu of Windows.
4.
Append "-G" and execute "Setup.exe" on the CD-ROM.
5.
Perform the uninstallation.
For option "-G", only SW1DNC-CCIEF-B Version 1.06G or later is supported.
Action displayed on the screen is not effective while installation
The following table shows the corrective actions when the screen is displayed.
Screens
Procedure
This screen is displayed when user account control is enabled.
Click [Allow] or the [Yes] button.
Click the [Yes] button.
MELSECPowerManager is installed and the Windows Power Options settings
are changed automatically.
For details of MELSECPowerManager, refer to the following section.
Page 231 MELSECPowerManager
If this screen is displayed during the installation or at the installation completion,
click "This program installed correctly".
If this screen is displayed when the installation is aborted, click the [Cancel]
button and close the screen.
Do not select "Reinstall using recommended settings". An incorrect module may
be installed.
16.2 Troubleshooting for Installation/Uninstallation
16 TROUBLESHOOTING
145
16