Microhard Systems Nano IP Series Operating Manual page 91

6.0 Configuration
SMTP Client: If the Nano IP Series network has Internet access, this protocol may be used to
send the data received on the serial port (COM1), in a selectable format (see Transfer Mode
(below)), to an e-mail addressee. Both the SMTP Server and the e-mail addressee must be
‗reachable' for his feature to function.
SMTP: Simple Mail
Transport Protocol is a
protocol used to transfer
mail across an IP
network.
Note: COM2 does not support this mode.
© Microhard Systems Inc.

Mail Subject
Enter a suitable ‗e-mail subject' (e-mail heading).
Default: COM1 Message

Mail Server (IP/Name)
IP address or ‗Name' of SMTP (Mail) Server.
Default: 0.0.0.0

Mail Recipient
A valid e-mail address for the intended addressee, entered in the proper format.
Default: host@

Message Max Size
Maximum size for the e-mail message.
Default: 1024

Timeout (s)
How long the unit will wait to gather data from the serial port before sending an e-
mail message; data will be sent immediately upon reaching Message Max Size.
Default: 10

Transfer Mode
Select how the data received on COM1 is to be sent to the email addressee.
Options are: Text, Attached File, Hex Code.
Default: Text
CONFIDENTIAL
IP Protocol Config (continued)
Values
TCP Client
TCP Server
TCP Client/Server
UDP Point-to-Point
UDP Point-to-Multipoint (P)
UDP Point-to-Multipoint(MP)
UDP Multipoint-to-Multipoint
SMTP Client
91