Microhard Systems Nano IP Series Operating Manual page 4

Important User Information (continued)
Regulatory Requirements
To satisfy FCC RF exposure requirements for mobile transmitting devices, a separation
distance of 23cm or more should be maintained between the antenna of this device and
persons during device operation. To ensure compliance, operations at closer than this
distance is not recommended. The antenna being used for this transmitter must not be
WARNING
co-located in conjunction with any other antenna or transmitter.
This device can only be used with Antennas listed in Appendix D. Please contact
Microhard Systems Inc. if you need more information or would like to order an antenna.
WARNING
MAXIMUM EIRP
FCC Regulations allow up to 36dBm Effective Isotropic Radiated Power (EIRP).
Therefore, the sum of the transmitted power (in dBm), the cabling loss and the antenna
gain cannot exceed 36dBm.
WARNING
EQUIPMENT LABELING
This device has been modularly approved. The manufacturer, product name, and FCC
and Industry Canada identifiers of this product must appear on the outside label of the
end-user equipment.
WARNING
SAMPLE LABEL REQUIREMENT:
For IPn920S and IPn920F Nano Series
FCCID: NS908P24
IC: 3143A-08P24
This device complies with Part 15 of the FCC Rules.
Operation is subject to the following two conditions:
(1) this device may not cause harmful interference,
and (2) this device must accept any interference
received including interference that may cause
undesired operation.
Please Note: These are only sample labels; different products contain different identifiers. The
actual identifiers should be seen on your devices if applicable.
© Microhard Systems Inc.
For IPn920T Nano Series
FCCID: NS908P25
IC: 3143A-08P25
This device complies with Part 15 of the FCC Rules.
Operation is subject to the following two conditions:
(1) this device may not cause harmful interference,
and (2) this device must accept any interference
received including interference that may cause
undesired operation.
CONFIDENTIAL 4