Microhard Systems Nano IP Series Operating Manual page 143

Appendix A: DiscoverIP Utility
To view the Web User Interface (Web UI) of a particular unit, either (a) highlight the target unit
and click the View WebUI soft button, or (b) double click on the MAC or IP address, or Descrip-
tion of the target unit.
Verify that the PC's
Network Settings (TCP/IP
Properties) are suited to
establishing a connection
with the Nano IP Series.
Selecting either method (above) will launch the PC's web browser to the IP Series Logon win-
dow.
If it would be necessary but is not convenient to change the TCP/IP Properties settings on the
PC note the following:
When received from the factory, the units are configured as DHCP, with an IP Address of
169.254.x.x, and Subnet Mask of 255.255.0.0.
Go to the DOS prompt on the PC and, for each time you connect to an IP Series (with ethernet
cable), enter
(Replace 192.168.1.110 with the IP Address of your PC.)
After the route has been added, you should be able to access the unit's WebUI logon page as
detailed above.
© Microhard Systems Inc.
Image A3: Select Target Nano IP Series
Image A4: Add Route
CONFIDENTIAL 143