Default Hardware Modes; Factory Jumper Settings; Figure 4-1 Factory Default Jumper Settings - Siemens SIMATIC TI505 User Manual

4.1

Default Hardware Modes

Factory Jumper
Settings
Channel 1
Channel 2
4-2 Using the Default Configurations
This chapter describes the default modes of operation selected by factory
installed jumpers. The jumpers are set at the factory to specific defaults.
Using these default settings (see Figure 4-1) and a minimal amount of
software programming, you can operate your High Speed Counter Encoder
module immediately after installing it in the I/O base. If you want to use the
optional configurations and counter modes, skip to Chapter 5.
Counter Inputs:
Counter: 1 2
Input A pulse
Input B pulse
Input A pulse
Input B pulse
Counter: 4 5
24-bit Counter Control Signals:
Output State Mode for Module Failure
or PLC Output Disable Signal:
24-bit Counter Output Options:

Figure 4-1 Factory Default Jumper Settings

3
— Jumper holding position
C in D input (clock/pulse)
— Jumper holding position
C in D input (clock/pulse)
Counter 1 (Ch1) 4 (Ch2)
6
MODFAIL
OUTDIS
Channel 1:
Channel 2:
Output Polarity:
Non-Inverted (1 = On)
High Speed Counter Encoder Module User Manual
16-Bit Counters 2, 3, 5, 6
jumper positions
External Index
Latch
Inhibit: Level
Ch1 Ch2 Filter:
100 kHz
Hold
(Freeze)
Compare
Counter 1, Output 1
Compare
Counter 4, Output 5
Outputs
1
2
3
4
5
6
7
8