Section 5 System Requirement And Specification; Cabling - NEC Univerge SV8100 System Hardware Manual

SECTION 5 SYSTEM REQUIREMENT AND SPECIFICATION

5.1

Cabling

This section provides cabling requirements and specifications for various
equipment used in the SV8100 system.
Figure 2-3 Connecting the DLC Using Twisted 2-Pair Cable
chassis connected with each of the multiline terminals and single line telephones by
a separate twisted 1-pair cable or 2-pair cable (only for Multiline Terminals).
Figure 2-3 Connecting the DLC Using Twisted 2-Pair Cable
Refer to the following tables for cabling requirements and specifications.
2-14
CHUYÊN CUNG CẤP TỔNG ĐÀI NEC
 Table 2-11 DT300 Series Loop Resistance and Cable Length
 Table 2-12DT700 Series Loop Resistance and Cable Length
 Table 2-13 Dterm Series i or Dterm IP Terminal Loop Resistance and
Cable Length
 Table 2-14 Cable Connection Between the Analog Port and the Single Line
Equipment
 Table 2-15 Cabling Requirements
http//vietpro.com.vn
UNIVERGE SV8100
is a diagram of the
SV8100 System Specifications