NEC Univerge SV8100 System Hardware Manual page 364

UNIVERGE SV8100
System Hardware Manual
CHUYÊN CUNG CẤP TỔNG ĐÀI NEC
4. Push the two stopper tabs through the slots to separate the tilt leg from
the leg support.
5. Lay the tilt leg and the leg support flat to expose ADA-L UNIT
compartment.
6. Carefully pry loose the knockout covering the bottom option interface
(Refer to Figure 6-25 Bottom Option Interface
Figure 6-25 Bottom Option Interface Knockout
7. Using the exposed Bottom Option Interface as a guide, install the
ADA-L UNIT in the bottom of the DTL/ITL multiline terminal. Push
down until left and right tabs are seated (Refer to
ADA-L UNIT).
8. Return tilt leg to original position.
9. Reconnect all cables previously disconnected.
Knockout).
Figure 6-26 Install ADA-L UNIT
http//vietpro.com.vn
Figure 6-26 Install
6-37