NEC Univerge SV8100 System Hardware Manual page 291

5-66
CHUYÊN CUNG CẤP TỔNG ĐÀI NEC
10. Open the small door covering the side option
connectors by pulling the cover latch toward you (refer
to Figure 5-72 Serial Cable Installed, ITL, DT700 only).
11. Connect the cable from the DCL-60-1( ) CONSOLE to
the Side Option Connector on the multiline terminal and
close the cover (ITL, DT700 only).
12. Set the height of the tilt leg on the multiline terminal to
the desired height.
13. Set the height of the tilt leg on the DCL-60-1( )
CONSOLE to match the tilt leg on the multiline terminal.
14. Attach the side panel to the side of the DCL-60-1( )
CONSOLE.
15. Return
CONSOLE to the buttons side up position.
16. Connect the digital cable to the LINE jack (DT300
Series).
17. Connect the AC Adapter cable (DT300/DT700 Series)
See
5-67.
Installing DT300/DT700 Series (DTL/ITL) Digital and IP Multiline Terminals
Figure 5-77 Serial Cable Installed
the multiline terminal
Figure 5-78 Connect AC Adapter Cable on page
http//vietpro.com.vn
UNIVERGE SV8100
and DCL-60-1( )