NEC Univerge SV8100 System Hardware Manual page 136

UNIVERGE SV8100
3.1.3
Switch
SW1 - Load Switch
SW6-1
SW6-2
SW6-3
SW6-4
System Hardware Manual
CHUYÊN CUNG CẤP TỔNG ĐÀI NEC
Switch Settings
Refer to Table 4-5 CD-CP00 Switch Settings
reset and with system power on.
page 4-14 shows the location of the SW1 switch on the CD-CP00 blade.
Table 4-5 CD-CP00 Switch Settings
USB Memory Status
With a system restart or a system reset while holding the SW1
switch:
When USB Memory is not
installed
When USB Memory is installed
When an unauthorized USB
device is installed
Do not change this switch from below setting
Table 4-6 CD-CP00 Switch 6 Settings
Configuration
OFF
OFF
Figure 4-3 CD-CP00 Blade Layout on
Cold Start occurs.
USB Memory contents loaded.
System does not start and an
"Illegal USB device is
connected" alarm is recorded.
ON Not Used
Test Mode
RS232C Select
Reset Configuration
ON
http//vietpro.com.vn
for system restart / system
Operation
Note
ON = Test Mode
OFF = Normal
ON = Use
OFF = Not Used
ON = Normal
OFF = ICE Mode
4-19