UNIVERGE SV8100
6.1.3
System Hardware Manual
CHUYÊN CUNG CẤP TỔNG ĐÀI NEC
4. Push the other end down until the locks on both sides lock into place
(refer to
Figure 4-33 Install the SO-DIMM
Figure 4-33 Install the SO-DIMM Memory
5. Install the Compact Flash drive into slot CN7, make sure the drive is
fully seated in the slot (refer to
Drive).
Figure 4-34 Install the Compact Flash Drive
LED Indications
6.1.3.1 Active LED – Green
The Active LED is controlled by the DSP and indicates the board
operational status.
♦ Off: Power off.
♦ On: Reset.
♦ Slow Flash: Board is running but not in sync with the chassis
yet.
♦ Fast Flash: Board is in sync with the chassis and operating
normally.
Memory).
Figure 4-34 Install the Compact Flash
http//vietpro.com.vn
4-89