NEC Univerge SV8100 System Hardware Manual page 133

4-16
CHUYÊN CUNG CẤP TỔNG ĐÀI NEC
The CD-CP00 provides:
♦ 200 trunk ports maximum
♦ 512 extension ports maximum
- 512 ports IP extensions maximum
- 368 digital/analog ports maximum
♦ 256 virtual extensions
♦ Connection for PZ-32IPLA/PZ-64IPLA/PZ-128IPLA Daughter Board
♦ Connection for PZ-VM21 Daughter Board
♦ Connection for Expanded Memory (PZ-ME50)
♦ Supports TAPI 2.x
♦ One Green Status LED
♦ Four Red Status LEDs
♦ Five diagnostic LEDs which indicate the status of various system
functions
♦ During normal operation, the "RUN" LED will be flashing and the
remaining LEDs are off
♦ Time Division Multiplex Switch (TDM Switch)
♦ Digital Phase Locked Loop (DPLL)
♦ Tone Generator
♦ Tone Processing DSP
♦ Connection for Memory Module
♦ DSP
♦ DTMF Tone Sender
♦ DTMF Tone Receiver
♦ DTG
♦ 32 Telephony Resources (for DTMF Receiver, Caller ID Receiver, and
Call Progress Tone Detection)
♦ System Tone Sender
♦ MF Receiver
♦ MF Sender
♦ MFC Tone Sender
♦ Call Progress Tone Detection
♦ C-Channel Control
♦ Conference: 64 Channels
♦ Caller ID Receiver; 32 Channels
♦ Caller ID Generator, 32 Channels for Analog Stations
♦ This can be expanded up to 20 by disabling 32 channels of the
Conference circuits and disabling the MFC Tone Sender
♦ A load switch which is used for initial system startup, resetting the
system, or when upgrading system software
♦ One Serial Port (null modem/cross-over cable required)
♦ One USB Port – USB 1.1
♦ One CompactFlash Card Slot
http//vietpro.com.vn
UNIVERGE SV8100
Installing the SV8100 Blades