NEC Univerge SV8100 System Hardware Manual page 126

UNIVERGE SV8100
2.6.2
2.6.3
Password
System Hardware Manual
CHUYÊN CUNG CẤP TỔNG ĐÀI NEC
Performing a Hot Start
The section describes how to load system software from flash memory
and customer data from RAM memory.
System software is loaded from flash memory, and the customer
data is loaded from RAM memory.
1. Turn the system power off.
2. After it has powered down, press the button again to power the system
back up. Wait approximately two minutes.
3. When the system has completed reloading the software, the Status
LED is flashing on the CD-CP00.
Resetting the System
This section describes the process of resetting a system that is running.
Observe the important information listed in below.
To reset the system:
2.6.3.1 Initial Programming
The system can be programmed using three methods:
♦ Programming using a multiline terminal
♦ PC Programming
♦ Web Programming
To program using a multiline terminal, enter programming mode:
1. Go to any working display telephone.
2. Do not lift the handset.
3. Press Speaker.
4. # * # * .
5. Dial the system password + Transfer.
IMPORTANT CONSIDERATIONS
In a newly installed system, use extension (port 1).
Password
http//vietpro.com.vn
4-9