NEC Univerge SV8100 System Hardware Manual page 369

6-42
CHUYÊN CUNG CẤP TỔNG ĐÀI NEC
8. Return tilt leg to original position.
9. For the APR adapter to be recognized correctly, before plugging in the
multiline terminal, make sure the extension number to be used for the
adapter is undefined in Program 10-03-01.
10. Plug the line cord back into the multiline terminal.
Before removing the adapter, to avoid any hardware
problems, unplug the line cord, then any other
adapter cables.
11. To determine the APR analog extension number. . .
10-03-04: Optional Installed Unit 1 (Read Only)
Displays the type of terminal installed. This can be used to verify that
the system recognizes the adapter.
10-03-06: Terminal Type (B2)
Assign the terminal type (12) for the telephone channel, which has the
APR Adapter installed.
When you want the APR to use the same extension number as the
telephone to which it is attached, remove the terminal type in this
option. With this setup, when the analog device is in use, it busies out
the terminal as there is no separate port number assigned for the
adapter. To reverse this, and allow the APR to have its own extension
number, reassign the terminal type (12) in this option.
10-03-07: Logical port Number (B2) (Read Only)
The port number of the APR Adapter is displayed for the extension
(APR ports = 193-512 with all software through 3.07). The ports are
assigned from the highest available port down.
Refer to Section 5: Data and SMDR
Figure 6-32 Install APR-L UNIT
for additional details.
Installing SV8100 Optional Equipment
http//vietpro.com.vn
UNIVERGE SV8100