NEC Univerge SV8100 System Hardware Manual page 213

6.2.4
6.2.5
4-96
CHUYÊN CUNG CẤP TỔNG ĐÀI NEC
LED Indications
Active LED – Green
The Active LED is controlled by the DSP and indicates the board
operational status.
♦ Off: Power off
♦ On: Reset
♦ Slow Flash: Board is running but not in sync with the chassis
♦ Fast Flash: Board is in sync with the chassis and operating normally
Busy LED – Red
♦ On: Application problem
CompactFlash Card Activity LED – Red
♦ CompactFlash Card Activity LED is controlled by the IDE controller
and indicates read/write activity on the CompactFlash card.
Connectors
Ethernet Connector
This connector is a single 10 Base-t/100 Base-T-X Mbps Ethernet
connector. This port has Auto-Medium Dependent Interface Crossover
(MDIX) to select either a straight-through or crossover Ethernet cable for
connection to a PC.
http//vietpro.com.vn
UNIVERGE SV8100
Installing the SV8100 Blades