NEC Univerge SV8100 System Hardware Manual page 124

UNIVERGE SV8100
2.3 Remove an Extension or Trunk Blade
Any blade, EXCEPT the ones listed below can be removed while the system is
powered up. To remove any blade listed below, the system must first be powered
down.
♦
♦
To remove an extension/trunk blade with the system running:
1. When LED 2 is extinguished, all extensions/trunks are idle.
2. Loosen the thumb screws on either side of the blade and pull it out of the chassis.
2.4 Uninstalling a Blade Slot Through Software
The installer can turn off (busy out) and delete (remove from software) blade slots in
the Controlling and Expansion Chassis in programming for port renumbering or to
replace it with a different blade. Deleting a blade may affect blade slot programming
capability. Refer to Program 90-05 in the UNIVERGE SV8100 Programming Manual
for detailed programming information.
2.5 Blade Capacities
The universal architecture of the UNIVERGE SV8100 provides flexibility when
installing blades. With the exception of the CD-CP00 blades, any blade can be
installed in any slot.
(SV8100) provides a list of the blades and the maximum capacities with various
chassis configurations.
System Hardware Manual
CHUYÊN CUNG CẤP TỔNG ĐÀI NEC
CD-CP00
PZ-BS10 and PZ-BS11
Table 2-4 Maximum System Capacities – Blades on page 2-9
http//vietpro.com.vn
4-7